Finished the hinges today and got a the boxes all sanded then marked and drilled for my makers mark done with the silicon bronze nail heads. Spent a couple of hours making jigs to inlet for the locks but put that asside till another day as I wanted to get a coat of BLO on the boxes to show any sanding misses. I thought I woud make a start on a seperate knife with a blank disc just to prove the method but the tool I had asked the engineers make (to his sugested design) was not up to the job so had to go down (about a 1/2hr away) with a drawing for what I wanted and will pick it up next week.
This is the boxes with a coat of BLO drying over night. They will get a more protective finish than the BLO later in the finishing stages. To round out the day I got the first inserts covered with the felt so pleased with the progress so far.