Aahh Damn!...you went and did it....this is going to be a long thread.
![Roll Eyes :rolleyes: :rolleyes:](https://cdn.jsdelivr.net/gh/twitter/twemoji@14.0.2/assets/72x72/1f644.png)
![D Beer Bottle :D Beer Bottle: :D Beer Bottle:](/styles/default/xenforo/smilies.original/d-beer-bottle.gif)
For those interested in learning a bit of history you might enjoy this long thread. For those not interested in learning a bit of trivia, I won't hold it against you.
The term paper cartridge relevant to the Civil War era isn't the same as what we consider to be paper cartridges today.
The "paper cartridge" during the Civil War was: think of it like this:
Using a piece of cigarette rolling paper, replace rolling tobacco in the paper with rolling a "charge" of powder, place at one end a round ball or a mini ball or a maxi ball, then tightly roll the paper and "glue" the edges together. Next "fold" or tightly twist the open end to seal the powder inside. Thus a "paper cartridge".
To use the "paper cartridge": bit, tear, cut the "fold" or twisted end and dump the powder down the barrel. Next place the paper into the barrel with the ball or "bullet" end at the muzzle. Using the ramrod push "ram" the paper and ball down the barrel seating the paper and ball against the powder charge. Finally cock the hammer and cap (or prime the pan, if using a flintlock). The firearm is ready to fire.
This "paper cartridge" enabled the shooter to more quickly reload his firearm(s) vs using the more time consuming method of measuring a charge, pooring the charge into the barrel, pulling out generally cloth material patching material over the muzzle, placing the ball on top and "thumbing" the ball into the muzzle, followed by either using a short start to start the ball down the barrel; [or just using the ramrod], last using the ramrod to push the ball down tightly against the powder charge.
Another form of "speed loader" that was used was the ball board: using any size relatively flat rectangular piece of wood, size depending on the caliber of rifle and how many pre pacthed balls they wanted readily available. Bore multiple holes into the piece of wood, with adequate spacing between the holes so the wood doesn't split or break. Each of the holes should only be big enough to snuggly hold a pre lubed, pre patched round ball.
To use: pour a measured charge down the barrel, place a pre patched ball located in the ball block over the muzzle and either using a short starter or the ramrod push the patched ball down the barrel seating the patch and ball against the powder charge.
The problem with using these crude "paper cartridges" is after several firings, paper residue would build up making it harder and harder to reload.
Rifled barrels were more prone or rather quicker to succumb to the paper residue build up because of the rifling thus making frequent barrel cleaning a necessity. Stopping to clean the barrel in the heat of battle could be fatal.
Smoothebores were still susceptible to paper fowling but could fire a few more rounds before the barrel needed to be cleaned.
What is a musket?
The consensus on the term musket, although it generally refers to having a smoothebore, actually it refers to all muzzleloading firearms.
There are basically 2 types of smoothebore long guns: Rifle Guns and Fowler Guns.
The rifle gun means it is not a short barrel gun, "pistol" ( nor revolver). The rifle gun unlike the fowler gun has 2 sights consisting of 1 rear sight and 1 generally a "blade" type front sight.
The fowler gun has only 1 front sight, generally a "bead" type sight.
Once rifling of the smoothebore barrel was started the term "rifled gun" or "rifled" was used to differentiate the smoothebore bore rifle from the rifled bore rifle.