.470 Empire?

[Glenn Slaven]

Talked to Pete at Qual Cart and he has a bunch of .470 Empire brass that needs to be used. So I have a project to build the gun now.

Anybody have any experience with it or load data?

It’s a .460 Weatherby cut back to fit in standard action, necked up to .474”.

I wouldn’t even know where to start for loads. Besides throwing about 70grains of H1000 and seeing what happens. lol

 

[rookhawk]

Talked to Pete at Qual Cart and he has a bunch of .470 Empire brass that needs to be used. So I have a project to build the gun now.

Anybody have any experience with it or load data?

It’s a .460 Weatherby cut back to fit in standard action, necked up to .474”.

I wouldn’t even know where to start for loads. Besides throwing about 70grains of H1000 and seeing what happens. lol

If you can look at the pressures and volumes of the case, you could compare it to a cordite load that was able to achieve that velocity. Start low, check for signs carefully, use 3031.

The major hazard I see is a more pronounced neck versus old kynoch loads that may cause pressure spikes if you’re required to use a wad.

Perhaps compare it to 470 Capstick and other 470 wildcats to see if the volume and dimensions are somewhat similar so you can start with a conservative loading?

 

[Flewis]

I would think you could start with the 460 a square short loading. That should be close.

 

[AimSmall]

Highly recommend acquiring QuickLoad software.

You'll thank me later.