Unfortunately I don't. I need to find someone to teach me how to and at the same time gather the funds to buy a kit. Thanks for the advice!greyfox said:Do you handload? Try a Barnes or Swift 150 and 165s, typically they are LONGER than other bullets which means a faster twist to stabilize the bullet,
Thanks a lot for the advice! Haven't had the opporunity as of yet to try any new cartridges, but will definitely take your advice into account; especially since im on a budget!Hi Matt,
As a non-reloader in SA, you're going to be limited to factory ammo. And as you've discovered, the only stuff produced in SA is PMP and imported ammo is expensive and not always available. The standard PMP stuff is not the greatest but is probably ok in a 30-06 because you're not in magnum territory where the bullet construction is really tested.
PMP does offer some fancier ammo - their African Elite range offers the 180gr Swift A-Frame which is about as good as it's going to get for a non-monolithic bullet in the '06. (from the reliably-available options here in SA)
A friend of mine who uses and '06 and only shoots factory ammo swears by the Remington Safari Grade which is also a 180gr Swift A-Frame. I don't think you'll go wrong with this ammo (you should be able to get some at Safari & Outdoor in Joburg). You will get a little poorer a little faster than if you use the PMP African Elite.
My advise is try the PMP African Elite and see how you go. Otherwise start reloading and take your pick of premium bullets!
The problem that I have with standard bullets is that they do not group as well as I like them to. I understand what you are trying to say and I've never had a problem hunting with standard ammo. However, the farm that I work on needs some animals to be culled and the best form of income from this is selling that meat to local butcheries. The problem that arises is that the butcheries will not accept an animal that has been dispatched with anything other than a headshot. Unfortunately the standard ammo does not quite qualify with accuracy when it comes to taking a 100m headshot. Thank you for your advice!The truth is that for a .30-06 you don't need some super premium bullet to hunt plains game, as long as you use the 180gr bullet.
Last year on my PG hunt to Limpopo, I loaded my '06 with 180gr Winchester Power Points. Even though this ammo sells for $20/box, it performed excellently!
I took both bull Oryx and Eland at close range. The recovered bullets all performed just as good as a premium bullet. Deep penetration and wide expansion. Retained weight was in the 75-80% range.
So even though the ammo makers might have you think you need a premium bonded bullet to take out an Impala, the truth is that standard bullets and normal velocities will easily take the largest PG.
(Magnum calibers is a different story - premiums required)
I'm Partial to 180g Sierra Game Kings
I too have had my best long range accuracy with Sierra bullets in various calibers (especially their old flat base standard hunting bullet, as opposed to their so called "target grade" bullets for some unknown reason).
If hunting PG at longer ranges, such as found in most of Namibia, South Africa's Eastern Cape and similar places, I would happily use Sierra Game King 180 grain in the .30-06 for most PG (but any .30 would not be my first choice on quite large animals like eland or giraffe, no matter what the bullet).
The Sierra GK bullet is a good one but, generally not an extremely tough one though.
So, if deciding to use the .30-06 on larger species like eland, zebra, blou wildebeest and such, I'd happily sacrifice a little accuracy (within reason) for the super toughness of the Swift A-Frame bullet.
For instance, if my .30-06 will put 3 Sierra 180 grainers into half an inch at 100 yds but it will only put 3 A-Frame 180 grainers into two inches at 100 yds, I would definitely go for the A-Frame.
in Zambia the other week
I used factory rounds , these were sako , hammerheads , in 220 grainers , mate these things got the job done , no worries ......
in Zambia the other week
I used factory rounds , these were sako , hammerheads , in 220 grainers , mate these things got the job done , no worries ......