Suppressor for a Winchester Model 70 Alaskan in .375?

[TN_Farmer]

I'm pretty sure it's not possible on this rifle, but how does one determine how much room needed for a suppressor on a rifle with a front sight?

Thanks!

 

[Sarg]

Keeping open sights on a rifle with a suppressor is a bit of a challenge & compromise, if an over barrel (best for OA shorter length & support of the suppressor) very very difficult & you end up with a strange setup which is hard to use, if you use a Can (end of barrel after moving sight back perhaps?) you still need extra high sights to make up for the bulk of the suppressor, a light weight or streamlined muffler most likely won’t be up to Magnum pressure.

I have an Oceania Defence Titanium, on one of my smaller caliber rifles, when I picked this up I thought it was made of paper Mache it was crazy light & doesn’t effect the handling at all, more so if you shorten the barrel.

​

To add that I believe you only need the length of the thread to be the same as the diameter to get the full strength, this on a Can.